[Shipping not included] Trailer slope rail for light trailers J-2000 Factory Zero Made in Japan Towing vehicle

Compatible with trailer slope rails, rail width 350 mm (center to center of rail)

By installing trailer slope rails, the JET can be loaded more smoothly, and the taillights, housing, etc. do not get submerged in water, so the trailer can be used for a long time.
It is possible.
Installation is easy, just attach the rail guide (included) to the trailer body.

● By installing a trailer slope rail, you can smoothly record the raising of the boat. Since the taillights, axle parts, etc. do not get submerged in water, the trailer will last longer.
● Since it is a 50x50 square pipe, there is no need to worry about the load when pulling it up with a winch.
(When pulling up, please support with 2-3 people. Forcibly pulling it up with only a winch may damage the winch.)
● When not in use, it can be easily stored inside the trailer and PWC body.
(Please note that it may not be possible to store it depending on the boat or trailer, and depending on the boat, the bottom may hit the rail guide part when loading it.)
A safe stainless steel round pipe is used for the handle part.
● The trailer side processing is simply attaching the rail guide to the rear frame of the trailer with U-bolts. )
* If the frame on the hub trailer side is low, the rear end of the slope rail will be close to the floor, which is dangerous, so please check.

Q. Can the "rail guide part" fit between the trailer's bunk rails and be attached to the rear frame? The size of the rail guide part is
420 mm wide.
In particular, if the rear end frame has a very deep R shape, the U-bolt may not fit. In such cases, if you prepare a larger U-bolt or similar, it will be possible.
* If it is attached to a frame with an R shape, the bottom of the boat may hit the rail guide part, so
please raise the bunk rail to adjust it. * If there is a license plate etc. at the attachment part, it is necessary to move the plate etc. (outside public roads)
* Depending on the compatibility between the boat and the trailer, the rail may not be able to be stored.
After installation, a space of approximately 85mm (height) x 71mm (width) is required for the rail to pass through.

[About payment and packaging]
For manufacturer-direct products
● Only handling fee (transfer bank). (Cash on delivery not accepted)
● Cannot be bundled

[About delivery]
If the recipient of this product is a private residence, an additional fee may be required for the billing amount.